Characteristics of magnetic filter and filter core：
1. Magnetic filter
can be directly installed on the top, side or bottom of the oil tank. The filter filter head is exposed to the oil tank, and the cylinder body is immersed in the oil tank.
2. The filter is equipped with permanent magnet, which can filter out the ferromagnetic particles over 1 micron in the oil.
3, with bypass valve: cold oil starting, due to the system liquid temperature is too low, flow pulsation and other factors resulting in the filter pressure difference is too large host can not work, and the filter core is blocked by pollutants, the filter cover under the parallel bypass valve will automatically open (open pressure of 0.4MPa) to protect the filter core and system normal operation.
4. Check valve: the filter is placed at the side or bottom of the oil tank. When the filter core is replaced, the oil in the oil tank will not flow out.
5. The liquid flow diffuser, which is composed of the liquid flow diffuser and the lower part of the barrel body, can make the returned oil flow into the oil tank smoothly, not easy to generate bubbles, reduce the re-entering air, reduce the disturbance of the accumulated pollutants, and play the role of coarse filtration when the bypass valve is opened.
6. It has visual indication and two-in-one sending device, overflow pipe and storage cup;
When the filter element
is gradually blocked, the blocking situation of the filter element can be observed on the visual meter, and at the same time, the filter element can be connected to the electricity for sending messages (the sending value is 0.35mpa). Overflow pipe and fouling cup are set at the bottom of the filter element, which can be taken out together with the filter element when changing, so as to avoid the contamination falling into the oil tank again.
7, cartridge filter material with glass fiber, high filtration precision, capacity big, the original small pressure loss, large amount, etc, and its filtering precision in absolute filtration precision calibration filter than beta 3, beta 5, beta 10, 20 200 or higher, beta, filtration efficiency eta 99.5% or higher.
The evaluation methods are iso16889-99 and GB/ t18853-2002.
8. It is convenient to install and connect and replace the filter element: the oil inlet is connected with a flange. For the installation of the flange between the filter head and the oil tank, the user can design and process 6 flange screw holes on the oil tank plate according to the size in the figure. Unscrew the top cover of the filter to replace the filter element or fuel the tank.
9,It is attached to the back to the oil hole: on the top of the filter head side and has two small oil return hole, can make the system a small amount of oil filter back into the tank or to within a small amount of gas tank, filter is installed in the side or at the bottom of the tank, unscrew holes cover and can be put sundry oil filter contains pollution, so as to prolong the service life of filter, and is advantageous to the purification of oil.
Yinbeier is specialized in producing filter elements and has 16 years of production experience. Welcome to purchase.