YINBEIER BLOG

We can make filters according to your requirements. Please tell me the photo and size

Air compressor filter elements replacement method and steps

  • Categories:NEWS
  • Author:Yinbeier
  • Origin:www.inbornfilter.com
  • Published on:2019-08-19

When the oil consumption of air compressor is greatly increased, check whether the oil filter and pipeline, return pipeline and other blocking and cleaning, oil consumption is still very large, the ge

Air compressor filter elements replacement method and steps

When the oil consumption of air compressor is greatly increased, check whether the oil filter and pipeline, return pipeline and other blocking and cleaning, oil consumption is still very large, the ge

  • Categories:NEWS
  • Author:Yinbeier
  • Origin:www.inbornfilter.com
  • Published on:2019-08-19
Information
When the oil consumption of air compressor is greatly increased, check whether the oil filter and pipeline, return pipeline and other blocking and cleaning, oil consumption is still very large, the general oil and gas separator has been degraded, need to be replaced in time; When the pressure difference between the two ends of the oil-gas separation filter element reaches 0.15mpa, it should be replaced. When the pressure difference is 0, it indicates that the filter element is faulty or the air flow has been short-circuited. At this time, the filter element should be replaced. Generally, the replacement time is 3000~4000 hours. If the environment is poor, the service time will be shortened. The replacement steps are as follows:
The external type is relatively simple, the air compressor stops, close the air pressure outlet, open the drain valve, and remove the old oil and gas separator to replace the new one after confirming that the system has no pressure.
Air compressor filter element built - in type
Replace the oil and gas separator correctly according to the following steps:
1. Stop the air compressor, close the air pressure outlet, open the drain valve, and confirm that there is no pressure in the system.
2. Disassemble the pipe above the oil and gas barrel, and disassemble the pipe from the pressure maintenance valve outlet to the cooler.
3. Remove return tubing.
4. Remove the fixing bolt of the cover on the oil and gas drum, and remove the top cover of the gas drum.
5. Remove the oil and gas separator and replace it with a new one.
Assemble them in reverse order.
Pay attention to the replacement of air compressor filter element
When the tubing is installed, it must be inserted into the bottom of the filter element. When replacing the oil and gas separator, pay attention to electrostatic discharge and connect the inner metal mesh with the oil drum shell. 5 staples can be nailed on the upper and lower pads, and set through, to prevent electrostatic accumulation ignition explosion, to prevent unclean products falling into the oil drum, so as not to affect the operation of the compressor.
Yinbeier specializes in the production of various industrial filter elements and hydraulic filter elements. And in place of PALL; HYDAC; MAHLE; PARKER; ARGO; FILTREC; STAUFF; VICKERS and other series of filter elements.

Scan the QR code to read on your phone

Contact YinBeiEr

Would you like to speak to someone directly?

Then contact us.

Our Service

Every YinBeiEr employee you talk to is committed to these six customer service principles.

底部1

Time of issue:2019-06-27 00:00:00

facebook

底部2

Time of issue:2019-06-27 00:00:00

youtube

底部3

Time of issue:2019-06-27 00:00:00

linkedin

底部4

Time of issue:2019-06-27 00:00:00

twitter

底部5

Time of issue:2019-06-27 00:00:00

pinterest

底部6

Time of issue:2019-06-27 00:00:00

skype

YINBEIER

Copyright © 2019 Yinbeier Hydraulic Filter Co., Ltd.        冀ICP备18021275号-1      Powered by: 300.cn